Removing and Replacing the Main Wireless LAN Antenna on the OMEN by HP VR PC Pack | HP OMEN | HP


To remove the main wireless LAN antenna, first remove the six bottom rubber feet and the top cover. Detach the black Phillips number one screw and the silver wide-head Phillips number one screw that secure the main antenna bracket inside the unit. Partially pull away the main antenna assembly. Carefully pry off the antenna from the wireless LAN board to fully remove the main wireless antenna
assembly from the unit. If you are replacing the antenna, remove the foam gasket from the top of the antenna. Pry the antenna and its foil tape off of its
bracket. To install a new main wireless antenna, press the antenna adhesive and foil tape down onto the main antenna bracket. Place the foam gasket for the main antenna over the foil tape. There is a small hole on the main wireless
antenna bracket that fits over an alignment pin on the chassis. To replace the main wireless antenna assembly, first carefully reattach the antenna cable
to the wireless LAN board. Align the hole on the bracket over its alignment pin. Secure the main wireless antenna bracket to the unit with the black Phillips number one system screw and the silver wide-head Phillips number one screw.

2 thoughts on “Removing and Replacing the Main Wireless LAN Antenna on the OMEN by HP VR PC Pack | HP OMEN | HP

  1. i lost my laptop and i want to know the mac id which was provided by the hp service centre after giving my FIR report to them, i want to know when the person who stole my laptop changes the wifi lan card then will the mac also change?? reply me sir as i am really in trouble, i hope there is no way to change the mac number?

Leave a Reply

Your email address will not be published. Required fields are marked *