How to Replace the Storage Drive Cable | EliteDesk 800, 705, ProDesk 400, 405, 600 Desktop PC | HP


How to Replace the Storage Drive Cable Before you begin: Remove the access panel and storage drive. Removal Press the storage drive cage lever down. Using minimal force, lift the locking bar up on the storage drive cable ZIF connector and disconnect the storage drive ribbon cable from the motherboard. Remove the two 9 mm T15 Torx-head screws that secure the storage drive cable to the storage drive cage. Slide the alignment pins on the storage drive cable out of the holes in the storage drive cage and remove. Replacement Slide the alignment pins on the storage drive cable into the holes in the storage drive cage. Replace the two 9 mm T15 Torx-head screws that secure the storage drive cage cable to the storage drive cage. Insert the storage drive cable into the storage drive ZIF connector on the motherboard and press the locking bar down to lock the cable into place.

Leave a Reply

Your email address will not be published. Required fields are marked *